Attaching Vinyl Siding To Concrete Wall

One choice might be vinyl siding.

Attaching vinyl siding to concrete wall. Using self tapping screws such as those by tapcon will fasten the strips to the concrete securely but concrete nails can be used as well. A concrete block garage is just about as sturdy as any garage can be. The basement walls are 8 poured concrete walls with the back wall being framed. Although the process of installing vinyl siding is relatively simple it helps to have assistance.

If you are useing a treated material for the fur strips then tyvek is pointless over concrete. If so then tyvek it. If you are installing furring strips over the concrete you better either 1 use treated material for this or 2 put tar paper between the cement and furring strip. In effect i would need to add a bit of spacing between the concrete and the siding.

This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole. There are at least three alternative ways to do it. Install another horizontal board along the top of the block wall and attach vertical boards at the. Is there any wood exposure with the concrete wall.

The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor. As a result the osb protrudes about a half inch farther out than the concrete. The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house. The backwall framing is framed against 8 walls that were not stepped down.

The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out. If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. But if you want a garage that is both sturdy and attractive you may want to cover your garage s exterior concrete block wall surface with something more becoming than the concrete block. Use concrete screws to attach the boards to the block.

I will be installing stained cedar siding on a new house being built with a walkout basement. Installing vinyl siding over concrete is similar to installing it over wood since you have to install wooden furring strips under the siding. Vinyl siding unlike other types. The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick.